Conair FC-33 Podręcznik Użytkownika Pobierz pdf (Strona 17)

UGG003/0398 CF Series Granulators

OPERATION/MAINTENANCE 13

6.4 Fault-finding

The granulator does not start

¥ Check that the emergency stop is not activated.

Reset by turning the button(s) in the direction of the arrow (counterclockwise).

¥ Check that the hopper is properly closed.

The granulator will not start if the hopper not is properly closed.

Tighten the star knobs properly to stop.

¥ Check that the screen box is properly closed.

The granulator will not start, if the screen box not is properly closed.

Tighten the star knobs properly to stop.

¥ Check the overload circuit breaker for the motor.

The motor has an overload circuit breaker, F1, in

the distribution box, which trips if you jam or over-

load the motor.

This is indicated in the window (A) which shows Ò0Ó.

Reset, press the ÒResetÓ button (B).

Check that there is no material left in the granulator

before restarting.

¥ Granulator with blower (CF series-U). Check the blower overload circuit breaker.

The granulator will not start if the blower does not start.

The blower motor has an overload circuit breaker, F2, in the distribution box,

which trips if you jam or overload the blower.

This is indicated in the window (A) which shows Ò0Ó.

Reset, press the ÒResetÓ button (B).

Check that there is no material left in the granulator before re-starting.

¥ Granulator with conveyor belt (CF series-KUB), if the conveyor belt does not

start Ð check the conveyor belt overload circuit breaker.

The conveyor belt motor has an overload circuit breaker, F3, in the distribution

box, which trips if you jam or overload the conveyor belt.

This is indicated in the window (A) which shows Ò0Ó.

Reset, press the ÒResetÓ button (B).

Check that there is no material left on the band before re-starting.

¥ Check the granulator knives and knife tolerance.

If the granulator knives are blunt and unsharpened, or if the knife clearance is

incorrect, this can result in stoppage. The granulator motor overload circuit break-

er will trip. Check the knives. Sharpen or replace the knives, or adjust the knife

clearance, see next chapter.

Check also the wiring diagram in chapter 9; supplements and deviations may be applicable.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

Brak uwag

Conair FC-33 Podręcznik Użytkownika Strona 17