Conair FC-33 Podręcznik Użytkownika Pobierz pdf (Strona 52)

CF Series Granulators UGG003/0398

48 ACCESSORIES

11.3 Band conveyor

The band conveyor is designed for transporting plastic waste. The conveyor is

constructed from steelbeam. The frame pieces are assembled with cross sec-

tions and screw.

The conveyor can be fitted with a metal-free zone and a metal detector.

Safety

When performing any work with the band conveyor, both the circuit-breaker

and the main circuit-breaker must be ÒOffÓ. Alternatively, the connector must

be pulled out of the power point on the granulatorÕs electrical cabinet!

The conveyor is designed for plastic waste. Do not use the conveyor for tasks

other than it is intended for.

Nobody should be on the conveyor or step on it during operation.

If the conveyor has stopped due to an error, or if the emergency stop has been

pressed, it must not be re-started until the cause has been established and the

appropriate action has been taken.

Mobile conveyors must always be transported in a lowered position.

Warning! When using the conveyor belt with carriers: Be careful not to let

the carriers catch your foot, arm, or article of clothing.

Installation

When installing, adjust so that the band conveyor is balanced diagonally.

If the floor of the installation site is very uneven, it should be made even

before installation.

Electrical connection

The band conveyor should be connected up by an authorised electrician.

Connect the cables to the electrical cabinet according to the markings and the

granulatorÕs electrical scheme (see chapter 9). Alternatively, connect the band

conveyor to the electrical cabinet with the connector.

Switch on the main circuit-breaker on the electrical cabinet. Press the start but-

ton and check that the belt moves in the right direction.

If the belt moves in the wrong direction.

Shift the two phases in the connection to the contactor for the band conveyor

in the electrical cabinet. Alternatively, shift the two phases in the connection to

the connector.

Starting

When the band conveyor is started for the first time, the beltÕs position on the

rollers should be checked. The belt must not move obliquely.

If the belt moves obliquely.

When the belt moves obliquely. Screw one adjusting screw at a time. Only

screw a 1/4 turn. Wait and let the belt move for a few minutes. Check, adjust,

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58

Brak uwag

Conair FC-33 Podręcznik Użytkownika Strona 52